How Should The Blade Of The Hedge Trimmer Be Adjusted And Replaced?

When using a hedge trimmer, it is found that the effect of pruning is not as good as before, so the blade of the electric hedge trimmer needs to be adjusted. How to adjust it? The following hedge trimmer technicians will introduce the adjustment method for you:

The electric hedge trimmer blade is fixed by a nut and a screw. When fixing, pay attention to loosening the nut first, and then screw the bolt clockwise until it stops. Note that the screw needs to be turned up for half a turn. To ensure a good tightness, a screwdriver must be used. After the blade has been adjusted with bolts and nuts, it needs to be lubricated again to make it smooth.

If it is found that the blade is dull and the electric hedge trimmer does not run smoothly, the blade needs to be sharpened. When sharpening, the surface or joint of the blade should be avoided.

When sanding the electric hedge trimmer blade, hold the sander at 45 degrees and sharpen the blade with a sanding edge.

When replacing the hedge trimmer blade, you need to turn off the power to prevent the machine from automatically starting to cause injury. In addition, you need to wear gloves and take protective measures when replacing the blade. The specific method is:

Remove the old blade, hold the cutter by hand, loosen the blade nut, take out the bolts and the blade, when taking the old blade off, remove all the bolts and nuts at the same time. Install the prepared new blade and tighten the nut. If there is weed on the blade, keep it clean.

Regarding the precautions for the replacement of the hedge trimmer blade, if you do not know the model and size of the replacement blade, you can consult the purchasing manufacturer. The above is the adjustment method of the electric hedge trimmer blade. When using the blade in daily life, the sharpness and tightness of the blade must be ensured.