What Problems Should Be Paid Attention To When Using Hedge Trimmer Fuel?

Before using the hedge trimmer, you should pay attention to three aspects of power, transmission and tools:

1. Engine:

(1), qualified gasoline and engine oil, ensure the mixing ratio (25:1);

(2) Regularly (25 hours) check and replace the air filter and check the spark plug;

(3) After working a tank of oil, you should rest for 10 minutes, and clean the loose gaskets of the machine after each work to ensure heat dissipation;

(4) When storing, it is necessary to clean the body, let off the mixed fuel, and burn the fuel in the carburetor; remove the spark plug, add 1-2ml two-stroke oil to the cylinder, pull the starter 2-3 times, and install the spark plug ;

2. Transmission: replenish grease regularly (25 hours);

3. Tool: Check the gap between the upper and lower edges regularly (25 hours), and adjust it in time (the interval is the half-circle thread interval of the bolt) to keep the edge sharp. Add oil to the blade every one hour of work, and the trimming diameter is less than or equal to 10mm.

Roadway vehicle-mounted hedge trimmer manufacturers remind everyone: in cold weather, be sure to turn on the engine for preheating, so as to avoid damage to internal parts caused by the direct work of the machine without buffering.

2. Notes on the use of fuel

(1) The fuel used by the engine of the hedge trimmer is a mixture of motor oil and gasoline, which is flammable. Please do not refuel or store fuel in places such as incinerators, burners, stoves, etc. that may cause fire;

(2) Do not smoke when working or refueling;

(3) If there is no fuel during use, be sure to stop the engine first, and then refuel after confirming that there are no fireworks around;

(4) If the fuel is spilled when refueling, be sure to wipe off the fuel attached to the body before starting the engine;

(5), seal the container after refueling, and then start the engine at a place more than 3 meters away from the fuel container;